Carrier 30RAP010-060 specifications Run Status Mode and Sub-Mode Directory, Strt

Table 3 — Run Status Mode and Sub-Mode Directory

SUB-MODE	KEYPAD		ITEM	DISPLAY	SUB-ITEM	DISPLAY	SUB-ITEM	DISPLAY	ITEM		COMMENT
	ENTRY								EXPANSION
VIEW			EWT	XXX.X °F					ENTERING FLUID TEMP
		ENTER
			LWT	XXX.X °F					LEAVING FLUID TEMP
			SETP	XXX.X °F					ACTIVE SETPOINT
			CTPT	XXX.X °F					CONTROL POINT
			LOD.F	XXX					LOAD/UNLOAD FACTOR
			STAT	X					CONTROL MODE	0	= Service Test
										1	= Off Local
										2	= Off CCN
										3	= Off Time
										4	= Off Emrgcy
										5	= On Local
										6	= On CCN
										7	= On Time
										8	= Ht Enabled
										9	= Pump Delay
			LD.PM						LEAD PUMP
			OCC	YES/NO					OCCUPIED
			LS.AC	YES/NO					LOW SOUND ACTIVE
			MODE	YES/NO					OVERRIDE MODES IN EFFECT
			CAP	XXX %					PERCENT TOTAL CAPACITY
			STGE	X					REQUESTED STAGE
			ALRM	XXX					CURRENT ALARMS & ALERTS
			TIME	XX.XX					TIME OF DAY		00.00-23.59
			MNTH	XX					MONTH OF YEAR	1 = January, 2 = February, etc.
			DATE	XX					DAY OF MONTH		01-31
			YEAR	XX					YEAR OF CENTURY
RUN			HRS.U	XXXX HRS					MACHINE OPERATING HOURS
		ENTER
			STR.U	XXXX					MACHINE STARTS
			HR.P1	XXXX.X					PUMP 1 RUN HOURS
			HR.P2	XXXX.X					PUMP 2 RUN HOURS
HOUR			HRS.A	XXXX HRS					CIRCUIT A RUN HOURS
		ENTER
			HRS.B	XXXX HRS					CIRCUIT B RUN HOURS		See Note
			HR.A1	XXXX HRS					COMPRESSOR A1 RUN HOURS
			HR.A2	XXXX HRS					COMPRESSOR A2 RUN HOURS
			HR.B1	XXXX HRS					COMPRESSOR B1 RUN HOURS		See Note
			HR.B2	XXXX HRS					COMPRESSOR B2 RUN HOURS		See Note
STRT			ST.A1	XXXX					COMPRESSOR A1 STARTS
		ENTER
			ST.A2	XXXX					COMPRESSOR A2 STARTS
			ST.B1	XXXX					COMPRESSOR B1 STARTS		See Note
			ST.B2	XXXX					COMPRESSOR B2 STARTS		See Note
PM			PUMP						PUMP MAINTENANCE
		ENTER
					SI.PM	XXXX HRS			PUMP SERVICE INTERVAL		Default: 8760
		ENTER
					P.1.DN	XXXX HRS			PUMP 1 SERVICE COUNTDOWN
					P.2.DN	XXXX HRS			PUMP 2 SERVICE COUNTDOWN
					P.1.MN	YES/NO			PUMP 1 MAINTENANCE DONE		User Entry
					P.2.MN	YES/NO			PUMP 2 MAINTENANCE DONE		User Entry

NOTE: If the unit has a single circuit, the Circuit B items will not appear in the display, except the ability to configure circuit B will be displayed.

6