Charging the Battery with the AC Adaptor
Pull back the rubber cover from the AC adaptor jack and insert the cable. The battery pack takes about 5 hours (when the Rugged PDA is turned off) to fully charge, and then the left side indicator LED lights green. Under the same condi- tions, the built in backup battery takes four hours to fully charge.
Warning!
Use the AC adaptor specified by CASIO. Using the AC adaptor that is not specified may cause a fire.
Remove the AC adaptor cable in the following order q ➔ w ➔ e.
q
| e |
| When the battery pack is fully |
| charged, remove the AC adaptor |
| cable and be sure to replace the |
w | rubber cover to its original position. |
1
If the left side indicator LED goes out during charging, then the internal protection circuit may have terminated charging. If this happens, remove the AC adaptor and the battery pack from the Rugged PDA and then reattach them again and then start charging again. If this happens frequently it may indicate a malfunction, contact your original dealer or authorized CASIO distributor.
• You can use the Rugged PDA while it is charging. However, the time to charge the Rugged PDA may vary greatly depending on the opera- tions performed on the Rugged PDA (and the surrounding tempera- ture or other factors).
•Charging requires a longer than normal time when doing initial setup after purchase or when charging a newly purchased battery pack for the first time.
Power Supply 37
