
Appendix
Adding a User to Cisco Unified CM
Adding a User to Cisco Unified CM
This section describes steps for adding a user to Cisco Unified CM. Follow one of the procedures in this section, depending on your operating system and the manner in which you are adding the user:
•Adding a User From an External LDAP Directory, page
•Adding a User Directly to Cisco Unified Communications Manager, page
Adding a User From an External LDAP Directory
If you added a user to an LDAP Directory (a
Procedure
Step 1 Log onto Cisco Unified Communications Manager Administration.
Step 2 Choose System > LDAP > LDAP Directory.
Step 3 Use the Find button to locate your LDAP directory.
Step 4 Click on the LDAP directory name.
Step 5 Click Perform Full Sync Now.
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory window determines when the next
Step 6 Proceed to “Configuring the Phone” section on page
Adding a User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager Administration by following these steps:
Procedure
Step 1 Choose User Management > End User, then click Add New. The End User Configuration window appears.
Step 2 In the User Information pane of this window, enter the following:
–User
Example: johndoe
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
|
|
| |
|
|