Cisco Systems 8941, 8945 manual Network Setup Menu, Option Description To Change, Select

Chapter

Network Setup Menu

Network Setup Menu

The Network Setup menu provides options for viewing and making a variety of network settings. Table 4-1describes these options and, where applicable, explains how to change them.

For information about how to access the Network Setup menu, see the “Displaying a Configuration Menu” section on page 4-2.

For information about the keys you can use to edit options, see the “Editing Values” section on page 4-3.

Table 4-1 Network Setup Menu Options

Option	Description	To Change
IPv4 Setup	In the IPv4 Setup submenu, you can do the following:	Scroll to IPv4 Setup and press
	• Enable or disable the phone to use the IP address that	Select.
	is assign by the DHCP server.
	• Manually set the IP Address, Subnet Mask, Default
	Routers, DNS Server, and Alternate TFTP servers.
	For more information on the IPv4 address fields, refer to
	Table 4-2.
Host Name	Unique host name that the DHCP server assigned to the	Display only—Cannot configure.
	phone.
Domain Name	Name of the Domain Name System (DNS) domain in	1. Set the DHCP Enabled option to
	which the phone resides.	No.
		2. Scroll to the Domain Name
		option, press the Edit softkey,
		and then enter a new domain
		name.
		3. Press the Apply softkey, then
		press Save.
Operational VLAN ID	Auxiliary Virtual Local Area Network (VLAN)	Display only—Cannot configure.
	configured on a Cisco Catalyst switch in which the phone	The phone obtains its Operational
	is a member.	VLAN ID via Cisco Discovery
	If the phone has not received an auxiliary VLAN, this	Protocol (CDP) from the switch to
	option indicates the Administrative VLAN.	which the phone is attached. To
	If neither the auxiliary VLAN nor the Administrative	assign a VLAN ID manually, use the
		Admin VLAN ID option.
	VLAN are configured, this option defaults to a VLAN ID
	of 4095.
Admin. VLAN ID	Auxiliary VLAN in which the phone is a member.	1. Scroll to the Admin. VLAN ID
	Used only if the phone does not receive an auxiliary	option, press the Edit softkey,
		and then enter a new Admin
	VLAN from the switch; otherwise it is ignored.
		VLAN setting.
		2. Press the Apply softkey, then
		press Save.

Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)

4-4 OL-20851-01