Cisco Systems 8945, 8941 manual PC Vlan, Device Phone Phone, Configuration

Chapter

Network Setup Menu

Table 4-1 Network Setup Menu Options (continued)

Option	Description		To Change
PC VLAN	Allows the phone to interoperate with 3rd party switches		1. Make sure the Admin VLAN ID
	that do not support a voice VLAN. The Admin VLAN ID		option is set.
	option must be set before you can change this option.		2. Scroll to the PC VLAN option,
			press the Edit softkey, and then
			enter a new PC VLAN setting.
			3. Press the Apply softkey, then
			press Save.
SW Port Setup	Speed and duplex of the network port. Valid values:		1. Unlock network setup options.
	•	Auto Negotiate	2. Scroll to the SW Port Setup
	• 1000 Full—1000-BaseT/full duplex (Supported only		option and then press the Edit
			softkey.
		for Cisco Unified IP Phone 8945.)
	•	100 Half—100-BaseT/half duplex	3. Scroll to the setting that you
			want and then press the Select
	•	100 Full—100-BaseT/full duplex
			button.
	•	10 Half—10-BaseT/half duplex
	•	10 Full—10-BaseT/full duplex
	If the phone is connected to a switch, configure the port
	on the switch to the same speed/duplex as the phone, or
	configure both to auto-negotiate.
	If you change the setting of this option, you must change
	the PC Port Configuration option to the same setting.
PC Port Setup	Speed and duplex of the access port. Valid values:		1. Unlock network setup options.
	•	Auto Negotiate	2. Scroll to the PC Port Setup
	•	1000 Full—1000-BaseT/full duplex	option and then press the Edit
			softkey.
	•	100 Half—100-BaseT/half duplex
			3. Scroll to the setting that you
	•	100 Full—100-BaseT/full duplex
			want and then press the Select
	•	10 Half—10-BaseT/half duplex	button.
	•	10 Full—10-BaseT/full duplex
	If the phone is connected to a switch, configure the port
	on the switch to the same speed/duplex as the phone, or
	configure both to auto-negotiate.
	If you change the setting of this option, you must change
	the SW Port Configuration option to the same setting.
LLDP-MED: Switch Port	Enables and disables Link Layer Discovery Protocol		From Cisco Unified CM
	Media Endpoint Discovery (LLDP-MED) on the switch		Administration, choose
	port. Use this setting to force the phone to use a specific		Device > Phone > Phone
	discovery protocol, which should match the protocol		Configuration.
	supported by the switch. Settings include:
	•	Enabled—default
	•	Disabled

Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)

OL-20851-01 4-5