2-28
CiscoASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter2 Unpacking and Installing the Chassis
Removing Components Before Installing the Chassis
Follow these steps to remove RSP and line cards from the chassis.
Step1 Use Figure2-24, Figure 2-25, or Figure 2-26 to identify each card and write down the card type and slot
number on a piece of paper. You will need this information when you reinstall the cards in the chassis to
be sure you reinstall each card in its original slot.
Step2 To remove a card starting at the lowest numbered slot:
a. Use a screwdriver to loosen the captive screws at the ends of the line card front panel.
b. Pivot the ejector levers to unseat the card from the backplane connector.
c. Slide the card out of the slot and place it directly into an antistatic bag or other ESD-preventive
container.
Figure2-24 Removing a Line Card from the Cisco ASR 9010 Router Chassis
aLoosen the captive screws. bPivot the ejector levers to
unseat the card from the
backplane connector.
cSlide the card out of the
chassis.