4-25
CiscoASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter4 Troubleshooting the Installation
Troubleshooting the Route Processor Subsystem
RSP and RP Front Panel Indicators
•LED Display Definitions, page4-25
•Compact Flash and Status LEDs, page4-27
•Ethernet Ports and Status LEDs, page4-27
•Auxiliary and Console Ports, page4-28
•Alphanumeric Message Displays, page4-28
•Flash Memory, page4-29

LED Display Definitions

The RSP card has eight discrete LED indicators and an LED dot-matrix display for system information.
The RSP-440, RSP-440 Lite, and RSP-880 have nine discrete LED indicators, a LED dot-matrix display
for system information, and three USB-specific LEDs. The RP has nine discrete LED indicators and a
LED dot-matrix display for system information.
Table 4 -3 describes the discrete LEDs and the three USB LEDs on the RSP, RSP-440, RSP-440 Lite, and
RSP-880 cards. Table 4 -4 describes the discrete LED definitions for the RP and RP2 cards.
Table4-3 RSP, RSP-440, RSP-440 Lite, RSP-880 Discrete LED Display Definitions
Indicator (Label) Color Description
Power Fail (FAIL) Red Standby Power Fail LED. The LED is turned off by the CAN bus controller
after it is up and running.
Off Standby power is normal.
Critical Alarm (CRIT) Red Critical Alarm LED. A critical alarm has occurred.
Off
(Default after reset)
No critical alarm has occurred.
Major Alarm (MAJ) Red Major alarm LED. A major alarm has occurred.
Off
(Default after reset)
No major alarm has occurred.
Minor Alarm (MIN) Amber Minor alarm LED. A minor alarm has occurred.
Off
(Default after reset)
No minor alarm has occurred.
Synchronization
(SYNC)
Green System timing is synchronized to an external timing source.
Amber System timing is free running.
Off LED never turns off.
Alarm Cutoff (ACO) Amber Alarm Cutoff has been enabled. The ACO push button was pressed after at
least one alarm has occurred.
Off
(Default after reset)
Alarm Cutoff is not enabled.
Internal Hard Disk
Drive (HDD)
[RSP only]
Green Hard Disk Drive is busy/active. The LED is driven by the SAS controller.
Off
(Default after reset)
Hard Disk Drive is not busy/active