2-31
CiscoASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter2 Unpacking and Installing the Chassis
Removing Components Before Installing the Chassis
Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR 9922 Router and Cisco ASR 9912 Router
This section describes how to remove the Route Processor (RP) cards, Fabric Card (FC), and Line Cards
(LCs) from the Cisco ASR 9922 Router and CiscoASR 9912 Router. Ta ble 2- 2 describes the
components and slot numbering for each router.
Table2-2 Router Components and Slot Numbering for the Cisco ASR 9922 Router and CiscoASR 9912 Router
Router Model Number Router Components and Slot Numbering
Cisco ASR 9922 Router •22 slots.
•Version 2 or version 3 power system. See Figure2-27 for version 2 DC and Figure 2-28 for
version 3 DC. See Figure2-29 for version 2 AC and Figure 2-30 for version 3 AC.
•Up to seven FC cards installed between the two RSP cards in the middle cage of the chassis.
•Ten line cards installed in slots 0 through 9 in the top card cage.
•Ten line cards installed upside down in slots 10 through 19 in the bottom card cage.
Cisco ASR 9912 Router •12 slots.
•Version 2 or version 3 power system, See Figure2-31 for version 2 DC or version 3 power
systems (Figure 2-31 for DC and Figure 2-32 for AC).
•Up to seven FC cards installed between the two RP cards above the power trays.
•Ten line cards installed in slots 0 through 9 below the fan trays.