2-64
CiscoASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter2 Unpacking and Installing the Chassis
Installing Chassis Accessories
Installing Optional Chassis Accessories on the Cisco ASR 9010 Router
The optional chassis accessories for the Cisco ASR 9010 Router include:
•Six ball studs
•Two L-shaped brackets
•Two hinge brackets (left and right side)
•Eight screws (plus one extra) for attaching the hinge brackets
•Four screws for attaching the L-shaped brackets
•Two doors (left and right side)
•One mid-cover with door lock
Note Installation of the optional accessory pieces also includes the base accessory ball studs and front grill.
The base accessory side strips are not used when installing the optional chassis accessories.
If you ordered the optional accessories set, follow these steps to install both the base and optional
accessories (Figure 2-57):
Step1 Attach the left L-shaped bracket (item 3 in Figure2-57) to the left hinge bracket (item 2 in Figure 2-57)
with two screws. Tighten the screws to a torque of 5in-lb (0.55 N-m).
Step2 Repeat Step 1 for the right hinge bracket and right L-shaped bracket.
Step3 Remove the two screws that secure the bottom edge of the cable management tray to the chassis.
Step4 Install six ball studs (three per side) into the chassis front edge (item 7 in Figure2-57 and Figure 2-58).
Tighten the ball studs to a torque of 8in-lb (0.90 N-m).