2-37
CiscoASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter2 Unpacking and Installing the Chassis
Removing Components Before Installing the Chassis
Figure2-32 Cisco ASR 9912 Router Components and Slot Numbering with Version 3 AC Power
System
Follow these steps to remove RP cards, FCs, and LCs from the Cisco ASR 9922 Router and Cisco ASR 9912 Router chassis.
Step1 Use Figure2-27 or Figure 2-31 to identify each card and then write down the card type and slot number
on a piece of paper. You will need this information when you reinstall the cards in the chassis to be sure you reinstall each card in its original slot.
Step2 To remove a FC card (Figure2-33 or Figure 2-34), starting at the lowest numbered slot:
a. Remove the air filter covering the front of the middle cage.
b. Use a screwdriver to loosen the captive screws at the ends of the FC front panel.
c. Push in both ejector lever release buttons.
Note Once any ejector lever release button is pushed in, the FC must by physically removed and
reinserted (OIR) to restart the FC.
d. Pivot the ejector levers to unseat the FC from the backplane connector.
363712
M3M2M1M0
M7M6M5M4
M11M10M9M8
PS0
Power modules
PS1
PS2
Fan trays
(rear instertion)
Line cards
LC0
LC1
LC2
LC3
LC4
LC5
LC6
LC7
LC8
LC9
Slot 0
Slot 1
Slot 2
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9
FT0
FT1
RP0
FC0
FC6
RP1
FC1
FC2
FC3
FC4
FC5
Power shelves/trays
M0 M1 M2
M0 M1 M2
M0 M1 M2