Cisco Systems DL-2159-05 manual Event Handling Setup

Chapter 7 Configuring Other Settings

Event Notification Setup

Table 7-2 Event Display Severity Levels (continued)

Severity Level	Description
System warning	The Warning settings indicate that a failure has occurred.
Protocol warning	• System refers to the access point as a whole.
Port warning	• Protocol refers to a specific communications protocol in use, such as
External warning	HTTP or IP.
	• Port refers to the access point’s Ethernet or radio network interface.
	• External refers to a device on the network other than the access point.
System information	The Information settings indicate a normal action that isn’t fatal (that is,
Protocol information	the port has been turned off, the rate setting has been changed, etc.)
Port information	• System refers to the access point as a whole.
External information	• Protocol refers to a specific communications protocol in use, such as
	HTTP or IP.
	• Port refers to the access point’s Ethernet or radio network interface.
	• External refers to a device on the network other than the access point.

These selections affect display of events only. They are used to filter information, not to remove it from the Event Log. To remove information from the Event Log, click Purge Log on the Event Log page.

Event Handling Setup Page

You use the Event Handling Setup page to determine how notification of the fatal, alert, warning, and information events should occur. You can choose to only count the events, display them to the console but not store them, record them after displaying them on the console, or notify someone of the occurrence after displaying and recording the event. Figure 7-10shows the Event Handling Setup page.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-05 7-21