Cisco Systems DL-2159-05 manual Vlan Summary Status, SSIDs Int, Mod, 13-4

Chapter 13 Diagnostics and Troubleshooting

Using Diagnostic Pages

The bar graph on the left side of the window displays the percentage used for each frequency; the highest current percentage used is labeled on the top left of the graph. In this example, the highest percentage used for any frequency is 77. The access point’s available frequencies are listed vertically across the bottom of the graph, from 2412 to 2462 GHz. The access point’s channel 1 is 2412 GHz, channel 2 is 2417 GHz, and so on up to channel 11, which is 2462 GHz.

The bar graph on the right side of the window displays the amount of noise on each frequency. Click Stop Test in the window or on the Radio Diagnostics page to stop the test.

VLAN Summary Status

Click VLAN Summary Status to reach the VLAN Summary Status page for your access point. Figure 13-4shows a typical VLAN Summary Status page.

Figure 13-4 VLAN Summary Status Page

The following links are available on the page:

•VLAN Detailed Setup—takes you to the VLAN Setup page, from which you can add, remove, or edit your VLAN configuration.

•ID(#)—takes you to the VLAN Setup page for the VLAN ID selected where you can edit the configuration.

•Def. Pol. Grp (if set)—takes you to the Policy Groups page, where you can edit the configuration.

SSIDs: Int, Mod

The SSIDs: Int, Mod link takes you to the AP Radio Internal Service Set Summary Status page for your access point. Figure 13-5shows a typical SSID Summary Status page for the Module radio.

Figure 13-5 AP Radio Module Service Set Summary Status Page

Cisco Aironet 1200 Series Access Point Software Configuration Guide

13-4 OL-2159-05