Cisco Systems DL-2159-05 manual Filter Setup, Protocol Filtering

Chapter 5 Configuring Filters and QoS

Filter Setup

Filter Setup

This section describes how to set up filtering to control the flow of data through the access point. You can filter data based on protocols and MAC addresses. Each type of filtering is explained in the following sections:

•Protocol Filtering, page 5-2

•MAC Address Filtering, page 5-6

Protocol Filtering

Protocol filters prevent or allow the use of specific protocols through the access point. You can set up individual protocol filters and enable each filter for one or more VLANs. You can filter protocols for wireless client devices, users on the wired LAN, or both. For example, an SNMP filter on the access point’s radio port prevents wireless client devices from using SNMP with the access point but does not block SNMP access from the wired LAN.

Use the Protocol Filters Setup page create and enable protocol filters for the access point’s Ethernet port and for the access point’s radio port. The Protocol Filters Setup page is shown on Figure 5-1.

Figure 5-1 Protocol Filters Setup Page

Follow this link path to reach the Protocol Filters Setup page:

1.On the Summary Status page, click Setup.

2.On the Setup page, click Protocol Filters in the Protocol Filters row under Associations.

You can create protocol filters or view existing filters by clicking Filters in the Ethernet or Radio rows of the Network Ports section of the Setup page. The screens are identical except for the name. Figure 5-2shows the Protocol Filters page.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

5-2 OL-2159-05