Cisco Systems DL-2159-05 manual Setting Up EAP Authentication, Enabling EAP on the Access Point

Chapter 8 Security Setup

Setting Up EAP Authentication

Setting Up EAP Authentication

During EAP authentication, the access point relays authentication messages between the RADIUS server on your network and the authenticating client device. This section provides instructions for:

•Enabling EAP on the Access Point

•Enabling EAP in Cisco Secure ACS

•Setting Up a Repeater Access Point As a LEAP Client

Enabling EAP on the Access Point

You use the Authenticator Configuration page and the AP Radio Data Encryption pages to set up and enable EAP authentication. The internal radio and the radio module both have an AP Radio Data Encryption page. Both pages contain the same settings. Figure 8-6shows the AP Radio Data Encryption page for the internal radio. Figure 8-8shows the Authenticator Configuration page.

Figure 8-8 Authenticator Configuration Page

Follow this link path to reach the Authenticator Configuration page:

1.On the Summary Status page, click Setup.

2.On the Setup page, click Security.

3.On the Security Setup page, click Authentication Server. Follow these steps to enable EAP on the access point:

Step 1 Follow the link path to the Authenticator Configuration page.

You can configure up to four servers for authentication services, so you can set up backup authenticators. If you set up more than one server for the same service, the server first in the list is the primary server for that service, and the others are used in list order when the previous server times out.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-05 8-15