Cisco Systems DL-2159-05 manual Enabling Vlan 802.1Q Tagging and Identifying the Native Vlan

Chapter 4 Configuring VLANs

A Wireless VLAN Deployment Example

Enabling VLAN (802.1Q) Tagging and Identifying the Native VLAN

When you have finished creating and configuring the VLANs and their associated SSIDs, you must enable VLAN IEEE 802.1Q tagging to make them operational. You must also identify the native VLAN. Follow these steps to enable VLAN IEEE 802.1Q tagging and identify the native VLAN.

Step 1 Browse to the Summary Status page and click VLAN in the Associations section. The VLAN Setup page appears (Figure 4-10).

Figure 4-10 VLAN Setup Page

Step 2 Verify that the VLANs you created appear in the Existing VLANs field.

Step 3 Click Cancel to return to the Setup page.

Step 4 Click Service Sets for the radio you are configuring. The AP Radio Service Sets page appears (Figure 4-11).

Note Figure 4-11shows a typical AP Radio Service Sets page. Your page may differ slightly.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-05 4-19