Cisco Systems DL-2159-05 manual Creating a Protocol Filter

Chapter 5 Configuring Filters and QoS

Filter Setup

Figure 5-2 Protocol Filters Page

Follow this link path to reach the AP Radio or Ethernet Protocol Filters page:

1.On the Summary Status page, click Setup.

2.Click Filters in the AP Radio: Internal, AP Radio: Module, or Ethernet row under Network Ports.

The left side of the Protocol Filters page contains links to the Ethertype Filters, the IP Protocol Filters, and the IP Port Filters pages.

Use the Protocol Filters pages to assign protocols to a filter set. Table B-1, Table B-2, and Table B-3in Appendix B list the protocols available on each page.

Creating a Protocol Filter

Follow these steps to create a protocol filter:

Step 1 Follow the link path to the Protocol Filters Setup page.

Step 2 Click Ethertype, IP Protocol, or IP Port to display the Filters page that contains the protocols you want to filter. Figure 5-3shows the IP Protocol Filters page.

Figure 5-3 IP Protocol Filters Page

Step 3	Enter a descriptive filter set name in the Set Name field.
Step 4	Enter an identification number in the Set ID entry field if you want to assign a specific SNMP identifier
	to the filter set. If you don’t enter an ID, an SNMP identifier will be assigned to the set automatically,
	starting with 1 for the first filter set and incrementing by one for each additional set.
	Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-05		5-3