Cisco Systems DL-2159-05 manual Vxdiagrouteshow, 13-26

Chapter 13 Diagnostics and Troubleshooting

Using Command-Line Diagnostics

:vxdiag_routeshow

Use the :vxdiag_routeshow command to display current routing information for the access point. The routing information might look like the following example:

ROUTE NET TABLE
destination	gateway	flags Refcnt Use	Interface

----------------------------------------------------------------------

0.0.0.0	10.84.139.129	3	1	1932	emac0
10.84.139.128	10.84.139.141	101	0	0	emac0

----------------------------------------------------------------------

ROUTE HOST TABLE
destination	gateway	flags Refcnt Use	Interface

----------------------------------------------------------------------

127.0.0.1 127.0.0.15 0 696 lo0

----------------------------------------------------------------------

These are descriptions for each column in the route net and route host tables:

•Destination—IP address of host to which access point is to be routed

•Gateway—IP address of host for forwarding packets not in the access point’s subnet

•Flags—see Table 13-2for a list of flags

•Refcnt—the number of hosts referencing this address

•Use—number of packets forwarded

•Interface—one of four possible interfaces:

–emac0 for Ethernet

–awc0 for internal radio

–awc1 for external radio

–lo0 for internal loopback

Follow the steps in the “Entering Diagnostic Commands” section on page 13-16to open the CLI and enter the :vxdiag_routeshow command.

	Cisco Aironet 1200 Series Access Point Software Configuration Guide
13-26	OL-2159-05