Cisco Systems DL-2159-05 manual AP Radio Identification Page for Internal Radio

Chapter 8 Security Setup

Setting Up EAP Authentication

Step 2 Follow this link path to browse to the radio’s AP Radio Identification page:

a.On the Summary Status page, click Setup.

b.On the Setup page, click Identification in the AP Radio row under Network Ports for the internal radio or the radio module.

Figure 8-9shows the AP Radio Identification page for the internal radio.

Figure 8-9 AP Radio Identification Page for Internal Radio

Step 3 Enter the network username you set up for the radio in Step 1 in the LEAP User Name entry field.

Step 4 Enter the network password you set up for the radio in Step 1 in the LEAP Password entry field.

Step 5 Click OK.

Step 6 Follow the steps in the “Enabling EAP on the Access Point” section on page 8-15to enable Network-EAP on the repeater access point.

The next time the repeater reboots, it performs LEAP authentication and associates to the root access point.

Note If the repeater access point fails to authenticate because the root access point or the RADIUS server is not set up correctly, you must reboot the repeater access point after correcting the problem. The repeater access point does not attempt to reauthenticate until it reboots.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

8-20 OL-2159-05