Cisco Systems DL-2159-05 manual Creating and Configuring the SSIDs

Chapter 4 Configuring VLANs

A Wireless VLAN Deployment Example

Step 3 Make the following entries on this page:

a.VLAN Name: Maintenance

b.VLAN Enable: Enabled

c.Default Priority: default

d.Default policy group: [0] None

e.Enhanced MIC verification for WEP: None

f.Temporal Key Integrity Protocol: None

g.WEP Key Rotation Interval: 0

h.Alert?: no

i.WEP Key 1: Set a 128-bit key.

Step 4 Click OK to return to the VLAN Setup page.

Step 5 Verify that your VLANs are listed in the Existing VLANs field.

Creating and Configuring the SSIDs

After you create the VLANs for your access point, you create the SSIDs to which the VLANs associate. Follow these steps to create the SSIDs.

Step 1 Click Setup to return to the Setup page.

Step 2 Click Service Sets for the radio you are configuring. The AP Radio Service Sets page appears (Figure 4-8).

Note Figure 4-8shows the page for the internal radio. The page for the module radio is identical.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

4-16 OL-2159-05