Cisco Systems DL-2159-05 manual Summary of Settings for Authentication Types, Leap

Chapter 8 Security Setup

Summary of Settings for Authentication Types

Summary of Settings for Authentication Types

Table 8-5lists the access point settings required to enable each authentication type and combinations of authentication types.

Table 8-5 Settings for Authentication Types

Authentication Types	Required Settings
LEAP	On the Authenticator Configuration page (shown in Figure 8-13):
	• Select an 802.1x protocol draft that matches the protocol draft used by
	client devices that associate with the access point.
	• Enter the name or IP address, type, port, shared secret, and timeout
	value for your RADIUS server.
	• Select the EAP check box under the server.
	On the AP Radio Data Encryption page for the internal radio or the radio
	module (shown in Figure 8-6):
	• Select the Network-EAPcheck box.
	• Enter a WEP key in key slot 1 and select 128-bitfrom the key size
	menu.
LEAP and static WEP	• Enter all the settings for LEAP authentication.
under 802.11 Open	On the AP Radio Data Encryption page for the internal radio or the radio
	module (shown in Figure 8-6):
	• Select the Open check box.
EAP-TLS and EAP-MD5	On the Authenticator Configuration page (shown in Figure 8-13):
	• Select an 802.1x protocol draft that matches the protocol draft used by
	client devices that associate with the access point.
	• Enter the name or IP address, type, port, shared secret, and timeout
	value for your RADIUS server.
	• Select the EAP check box under the server.
	On the AP Radio Data Encryption page for the internal radio or the radio
	module (shown in Figure 8-6):
	• Select the Open and Network-EAPcheck boxes.
	• Select the Require EAP check box under Open.
	Note Selecting Require EAP blocks non-EAP client devices from
	using the access point.
	• Enter a WEP key in key slot 1 and select 128-bitfrom the key size
	drop-down menu.

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-05 8-27