Cisco Systems DL-2159-05 manual Status

Appendix C Event Log Messages

Message Descriptions

Table C-1 Event Log Messages and Descriptions (continued)

		EMBLEM	Possible Cause or
Severity	Event Description	Mnemonic	Recommended Action
Protocol	Port ifDescr is not an 802.11	PRO80211_BIND	Reboot the access point.
Fatal	network	_ERR2
	ifDescr: Name of network
	interface
Protocol	Unknown port ifDescr	PRO80211_	Reboot the access point.
Fatal	ifDescr: Name of network	PORT_UNKN
	interface
Protocol	Can not bind 802.11 Control to	PRO80211_	Reboot the access point.
Fatal	port device	CTRL_BIND_
	device: the network interface	ERR
	device name/unit number
Protocol	Inconsistent VxWorks END	PRO80211_BIND	Reboot the access point.
Fatal	control block for port ifDescr	_ERR3
	ifDescr: Name of network
	interface
Port Fatal	Card for device ifDescr cannot	DEV80211_CFG	The access point radio might
	be successfully configured (error	_BAD	have failed. Reload the access
	status)		point firmware.
	ifDescr: Name of network
	interface
	status: radio status
Port Fatal	Radio MAC for device ifDescr	MAC_ENABLE_	The access point radio might
	can not be Enabled (error status)	FAILED	have failed. Reload the access
	ifDescr: Name of network		point firmware.
	interface
	status: device status number
Port Fatal	Radio Enable Failed with error	RADIO_EN_	Reset the access point WEP
	“Bad Authentication Type.”	ERROR	configuration. If this message
	Temporarily Disabling WEP		appears continuously, reload the
	Encryption and re-Attempting		access point firmware.
	Enable. This error may indicate
	tampering with the radio and/or
	its encryption keys!
Port Fatal	Card for device ifDescr cannot	DEVAWC_CFG_	Reset the access point radio
	be successfully configured (error	BAD	configuration parameters to
	status)		defaults and reconfigure the
	ifDescr: Name of network		radio parameters.
	interface
	status: network interface card
	status

Cisco Aironet 1200 Series Access Point Software Configuration Guide

OL-2159-05 C-15