Cisco Systems UBR7225VXR specifications Equipment Racks

Models: UBR7225VXR

1 184
Download 184 pages 62.36 Kb
Page 47
Image 47

Chapter 2 Preparing the Cisco uBR7225VXR Router for Installation

Provisioning the Cable Headend

Any additional interface equipment you need, such as transceivers, hubs, switches, modems, channel service units (CSUs), or data service units (DSUs)

Cable pinouts if you plan to build your cables

Before installing the Cisco uBR7225VXR router, have all additional external equipment and cables available. The information listed above is available at Cisco.com. For ordering information, contact a customer service representative.

Equipment Racks

The rack-mounting hardware included with the Cisco uBR7225VXR universal broadband router is suitable for most 19-inch equipment racks and telco-type racks. To easily access field-replaceable units (FRUs) while the router is installed in a rack, ensure that you have access to the front and rear of the router.

Before using a particular rack, check for obstructions (such as a power strip) that could impair rack-mount installation. If a power strip impairs a rear rack-mount installation, remove the power strip before installing the Cisco uBR7225VXR router in the rack, then replace it after the chassis is installed. As an alternative, you can mount the Cisco uBR7225VXR router on an equipment shelf if the rack dimensions allow you to secure the router to the shelf, and the overall configuration permits safe installation and access. However, we recommend rack-mounting the Cisco uBR7225VXR router. Figure 2-3 on page 2-16shows the Cisco uBR7225VXR router footprint and outer dimensions.

When rack-mounting the Cisco uBR7225VXR router, consider the following information:

To mount the router between two posts or rails using the brackets, the inner clearance (the width between the inner sides of the two posts or rails) must be at least 17.5 inches (44.45 cm).

The height of the Cisco uBR7225VXR chassis is 3.5 inches (8.89 cm).

When mounting the router in four-post or telco-type racks, be sure to use all the screws and the brackets provided to secure the chassis to the rack posts.

 

 

Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide

 

 

 

 

 

 

OL-17309-02

 

 

2-15

 

 

 

 

 

Page 47
Image 47
Cisco Systems UBR7225VXR specifications Equipment Racks