Chapter 2 Preparing the Cisco uBR7225VXR Router for Installation

Component Checklists

Table 2-2

Site Preparation Checklist (continued)

 

 

 

 

Task

Verified By

Date

Gatekeeper and gateway equipment installed and configured.

Dial plan based on the supported VoIP protocol used—H.323 or SGCP.

Component Checklists

Check off the equipment as it is unpacked.

Titles and quantities of documents will vary.

Table 2-3 provides the list to verify the contents of the shipping container for the Cisco uBR7225VXR router.

Table 2-3

Cisco uBR7225VXR Router Component List

 

 

Description

Received

Cisco uBR7225VXR chassis

Network processing engine

Up to two AC-input power supplies and power cords (blank power supply filler plate should be installed in empty power supply slot)

Up to two cable interface line cards (blank cable interface line cards should be installed in empty cable interface line card slots)

CompactFlash Disk

The following accessories might arrive in separate shipping containers:

Rack-mount and cable-management kit—Two rack-mount brackets, cable-management bracket, eight M4 x 6-mm Phillips flathead screws, four M3 x 6-mm Phillips panhead screws, and four 10/32 x 3/8-inch slotted binderhead screws

AC-input power cables—Up to two AC-input power cables (if separate AC-input power supply ordered)

Documentation, including the following:

Cisco Information Packet

Cisco Network Registrar documentation—if ordered

Cisco IOS software documentation set—if ordered

Note All hardware and software documentation is also found at the following URL:

http://www.cisco.com/en/US/products/hw/cable/ps2217/tsd_products_support_series_home.ht ml

 

Cisco uBR7225VXR Universal Broadband Router Hardware Installation Guide

2-18

OL-17309-02

Page 50
Image 50
Cisco Systems UBR7225VXR specifications Component Checklists, Task Verified By Date