Installing an optional module in PowerConnect B-FCX624 and PowerConnect B-FCX648 devices

2

Installing an optional module in PowerConnect B-FCX624 and PowerConnect B-FCX648 devices

PowerConnect B-FCX624 and PowerConnect B-FCX648 switches support an optional four-port 1 Gbps SFP module or four-port 10 Gbps SFP+ module. The 10 Gbps SFP+ module allows you to use your device in a stack. Figure 31 shows how to install an optional SFP or SFP+ module.

FIGURE 31 Installing an optional module in PowerConnect B-FCX624-E, PowerConnect B-FCX624-I, PowerConnect B-FCX648-E, and PowerConnect B-FCX648-I devices

CAUTION

Optional SFP and SFP+ modules are not hot-swappable. Be sure to power-down your device before you install or replace a module.

Perform these steps to install an optional module.

1.Remove the blank metal plate (or a installed module) from the slot by removing the two screws with a Phillips screwdriver.

2.Before opening the module package, touch the bag to the switch casing to discharge any static electricity. It is recommended that you wear an ESD wrist strap during installation.

3.Remove the module from the anti-static shielded bag.

4.Hold the module level, guide it into the carrier rails and gently push it into the slot until it firmly engages with the connector.

5.When the module is engaged, tighten the retainer screws to secure the module in the slot.

6.When the switch is powered on, the LEDs will follow the LED status as described in “Port, system, and power status LEDs for PowerConnect B-FCX624 and PowerConnect B-FCX648”on page 11.

NOTE

If you want ports 1 and 2 on the 10 Gbps module to pass regular Ethernet traffic, you must first disable stacking on these ports. For more information, see the PowerConnect B-FCX Series Configuration Guide

PowerConnect B-FCX Switch Hardware Installation Guide

31

53-1002267-01

 

Page 41
Image 41
Dell B-FCX manual