Dell R420xr owner manual IDRAC Enterprise Card Optional, Installing Expansion-Card Risers 1

5.riser guides (2)

5.Replace the expansion-card riser.

6.Close the system.

7.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing Expansion-Card Risers 1 And 2

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.If applicable, reinstall the expansion card(s) into the expansion-card riser.

2.Align the expansion-card riser with the connector and the riser guides on the system board.

3.Lower the expansion-card riser into place until the expansion-card riser connector is fully seated in the connector.

4.Close the system.

5.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

6.Install any device drivers required for the card as described in the documentation for the card.

iDRAC Enterprise Card (Optional)

The iDRAC Enterprise card supports:

•one 1GbE Ethernet port

•SD vFlash card

Removing The iDRAC Enterprise Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2.Open the system.

3.Disconnect any cables connected to the iDRAC Enterprise card.

4.Lift the expansion-card latch.

5.If installed, remove the expansion card from expansion-card riser 1.

6.Supporting the expansion-card riser by the touch points, hold the iDRAC Enterprise card by its edges and remove it from the iDRAC Enterprise card connector on the riser.

60