Delta Electronics VFD-F Series manual Status monitor Read only, 5-56

VFD-F Series

3.5 Address List

The contents of available addresses are shown as below:

Content

AC drive

Parameters

Command Write only

Status monitor Read only

Address

GGnnH

2000H

2001H

2002H

2100H

Function

GGmeans parameter group, nn means parameter number, for example, the address of Pr 04-01 is 0401H. Referencing to chapter 5 for the function of each parameter. When reading parameter by command code 03H, only one parameter can be read at one time.

00B: No function

Bit 0-1	01B: Stop
	10B: Run
	11B: Jog + Run
Bit 2-3	Reserved
	00B: No function
Bit 4-5	01B: FWD
	10B: REV
	11B: Change direction
	00B: Comm. forced 1st accel/decel
Bit 6-7	01B: Comm. forced 2nd accel/decel
	10B: Comm. forced 3rd accel/decel
	11B: Comm. forced 4th accel/decel
Bit 8-11 Represented 16 step speeds.
Bit 12	0: No comm. multi step speed or accel/decel time
	1: Comm. multi step speed or accel/decel time
Bit 13-15	Reserved
Frequency command
Bit 0	1: EF (external fault) on
Bit 1	1: Reset
Bit 2	1: External Base Block (B.B) on
	0: External Base Block (B.B) off
Error code:

00:No fault occurred

01:Over-current (oc)

02:Over-voltage (ov)

03:Overheat (oH)

04:Overload (oL)

05:Electronic thermal relay (oL1)

06:EF (external fault)

07:AC drive IGBT fault (occ)

08:CPU failure (cF3)

09:Hardware protection failure (HPF)

10:Over current during acceleration (ocA)

11:Over current during deceleration (ocd)

12:Over current during steady state operation (ocn)

13:Ground Fault (GFF)

5-56 DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED