Delta Electronics VFD-F Series manual Description Of Parameter Settings

VFD-F Series

CHAPTER 5 DESCRIPTION OF PARAMETER SETTINGS

: This parameter can be set during operation.

5.1Group 0: AC Drive Status Parameters Group 0 is read-only.

00 - 00			Software Version			Factory setting: Read Only
	This parameter displays the software version of AC drive.
00 - 01			AC Drive Status Indication 1			Factory setting: Read Only
	This parameter displays the AC drive status.
	Code		AC Drive Status			Explanation
	00	No fault occurred
	01	oc			over current
	02	ov			over voltage
	03	oH			over temperature
	04	oL			overload
	05	oL1			electronic thermal relay
	06	EF (external fault)			EF-DCM is closed
	07	occ (AC drive IGBT fault )			IGBT short circuit protection
	08	cF3 (CPU failure)			Abnormal A/D reading during self-check
	09	HPF (hardware protection failure)			Hardware protection function activated
					during self-check.
	10	ocA (over current during acceleration)			Output current exceeds protection level
					during acceleration
	11	ocd (over current during deceleration)			Output current exceeds protection level
					during deceleration
	12	ocn (over current during steady state			Output current exceeds protection level
		operation)			during steady state operation.
	13	GFF (ground fault)			Ground fault protection feature activated
	14	Lv (under voltage)			Low input voltage
	15	cF1			EEPROM input data is abnormal
	16	cF2			EEPROM output data is abnormal
	17	bb (base block)			BB is set and activated
	18	oL2 (motor over load 2)			Output current exceeds rated motor current
	19	Reserved
	20	codE			software or password protection
	21	EF1 (external emergency stop)			EF1 (a multifunction-DCM is enabled)
	22	PHL (phase loss)			Input power lacks phase.
					3-phase input power is unbalance and
					exceeds specification.
	23	Lc (Low Current)			Low current detection during operation.
	24	FbL(Feedback Loss)			Feedback signal is abnormal.
	25	Reserved
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED				5-1

5