Dialogic 6.2 manual November 270

				General Information
		Table 13. Robbed Bit Signaling Timers (Continued)
Timer	Granularity		Definition	Default Value
dptimer_	10 ms		Dial Pulse Interdigit.	IISDN56_DPINTERDGT_TIMER_
interdigit			Time between digits when	DEFAULT (30)
			performing digit outpulsing.	300 ms
dptimer_make	10 ms		Dial Pulse Make.	IISDN56_DPMAKE_TIMER_
			Off-hook (make) time for	DEFAULT (6)
			outdialing a dial pulse digit.	60 ms
dptimer_post_	10 ms		Amount of time the protocol will	IISDN56_DPPOSTWINK_TIMER_
wink			keep the line in idle state after	DEFAULT (5)
			transmission of a wink signal	50 ms
			before reporting to the host the
			wink has been sent. This
			ensures a minimum period for
			the idle signal to be present on
			the line, even if the host sends
			the line offhook immediately
			after being notified of an
			incoming call or end of a
			transmitted wink.
dptimer_pre_	10 ms		Dial Pulse Prewink.	IISDN56_DPPREWINK_TIMER_
wink			Time Instant ISDN pauses	DEFAULT (5)
			before sending a wink signal.	50 ms
dptimer_wink	10 ms		Duration of a transmitted wink.	IISDN56_DPWINK_TIMER_
				DEFAULT (20)
				200 ms
first_indigit_	50 ms		Normal First Interdigit Timer.	IISDN56_FIRST_DGT_TIMER_
timer			While racking incoming digits,	DEFAULT (60)
			the maximum time to wait for	3 seconds
			the first digit before giving up
			and returning an incomplete
			rack (valid during normal
			interdigit timing only).
fixed_pause_	50 ms		Fixed Pause Wait Timer.	IISDN56_FIXP_TIMER_
timer			Time to wait before allowing	DEFAULT (2)
			outgoing dialing to commence	100 ms
			(applies when outgoing start dial
			type is fixed pause only).

November 2009 270