Dialogic 6.2 manual Protocol Control, November 345

				Enabling the R2 Protocol
	Table 19. R2 MFC Inter-register Signaling Parameters (Continued)
Name		Description	Units	Range
pulseToneDuration		Duration of a backward pulse	ms	Typically [100 - 200]
		signal (Ref. ITU Q.442).
Outbound MFC Timers
forwardToneMaxOnTime		Time associated with the outbound	Seconds	This is typically in the
		“T1” timer that supervises the		range [12-18], but refer
		interval between start of a forward		to network
		tone and cessation of the forward		specification.
		tone (Ref. ITU Q.476).
forwardToneMaxOffTime		Time associated with the outbound	Seconds	Typically set to > 24
		“T2” timer that supervises the		(Q.476), but refer to
		interval when no forward tones are
				network specification.
		sent. This interval consists of the
		period waiting for the backward
		tone to stop, as well as any
		additional time needed for the next
		forward tone to be known.
forwardGroup2MaxOnTime		Not used.	Seconds	Not used.
Protocol Control
dnisTimeOutAction		Not used.		Not used.

Protocol State Transition Specification

Each of the following is an array of length 16. Element zero is invalid and elements 1-15 correspond to R2 MF signals 1-15. These allow the Call Setup Service Pack software to construct the proper state transition tables for a given trunk.

Forward Channel Signal Definitions

endOfDNIS	Signal end of DNIS pulsing; NOT	Table 20
	defined in some variants.
endOfANI_Available	Signal end of ANI identification	Table 20
	when ANI digits are available.
InfoNotAvailable	Indicates that ANI information is	Table 20
	restricted. There is usually no need
	to distinguish from signal
	“aniRequestNotAccepted”.
aniCategoryDefault	Default Group 1 category. Used if	Table 20
	category is not specified in a given
	call request.

November 2009 345