Dish Network 222 manual CH 3-4 Out, Connecting to the Remote TVS TV1 or TV2

Chapter 11 Two Color.fm Page 87 Wednesday, August 2, 2006 1:00 PM

Connections and Setup

Connecting to the Remote TVs (TV1 or TV2)

CH 3-4 Out

Use these instructions if you’d like to connect your receiver to an SD television.

1Connect a coaxial cable from the CH 3-4 output on the receiver to the nearby TV’s tuner port.

2Place the white CH 3-4 sticker on the cable near where the cable connects to the receiver (the stickers are inside the front cover of this guide).

3Plug in the power cord for the receiver.

4Turn on the receiver with the front panel power button and make sure the TV1 indicator is lit.

5Turn on the nearby TV.

6Tune the TV to channel 3. Confirm that you are getting a picture from the receiver.

7If you do not see the Point Dish screen, tune the TV to channel 4.

Note: If you want to change the channel that the CH 3-4 port provides to your TV, see Changing the TV1 and TV2 Output Channels on page 37.

8Place one of the channel stickers (3 or 4) near or on your TV. The stickers are located in the inside front cover of this guide.

CONNECTING TO THE REMOTE TVS (TV1 OR TV2)

This section describes how to connect the receiver CH 21–69 Out connection to the cable- ready remote TV located in another room away from the receiver. You can use these instructions to connect TVs in your house to see programming from TV1 or TV2. This installation uses your in-home cable system. If your house does not have built-in cabling, it will be necessary to run cables from the receiver to each remote TV. Due to the difficulty of this installation, you should consider having this professionally installed. Call DISH Network at 1-800-333-DISH (3474).

If you’re using TV1 in a room away from the receiver, be sure to order the replacement remote control that uses UHF Pro signals instead of IR. Call your DISH Network retailer or go to www.dishnetwork.com, select Products and Services, and then click on Accessories.

87