222.book Page 69 Tuesday, July 25, 2006 1:30 PM
Remote Controls
The Recover Button
Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs. However, to use RECOVER with your remote TV (or VCR), you need to program RECOVER with the specific channel (for example, channel 60) that you use to watch TV2 programming. The following instructions describe how to program RECOVER to tune your remote TV (or VCR) back to a selected channel.
Using the Recover Button
The following setup is required to use RECOVER:
•The remote control must be set up to control the TV and, if installed, the VCR.
•If a VCR is installed, make sure it is connected as shown on page 94.
•On a remote TV, RECOVER must be programmed to tune your remote TV to the spe- cific channel to receive TV2 programming (for example, channel 60), using the instructions on page 69.
Note: Press any remote control button other than RECOVER to end this procedure.
Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV video. If RECOVER is programmed to a specific channel (see page 69), RECOVER will tune the TV to the specific channel (for example, channel 60).
69
