Modifying a Wash Protocol
Modifying a Wash Protocol
An existing wash protocol can be modified by using many of the same commands that are used to create a wash protocol.
To modify a wash protocol:
1.Display the main menu:
1:NAME_01
SETUP PROGRAM
2.Use the up and down scroll keys to select the wash protocol to be modified (or enter the number using the keypad). The display will read:
4: NAME_04
SETUP PROGRAM
3.Select PROGRAM. If the wash protocol is password protected, the display will read:
Enter password
Note: If a Password is not specified for the selected wash protocol, the display will read as shown in Step 5.
4. Enter the Password using the keypad and press ENTER.
Note: If the Password is entered incorrectly an error message is displayed. The operator is allowed three attempts to enter the password. After the third attempt, the main menu
(Step 1) will again be displayed.
Note: If the password for a protocol is lost, the ability to access the method and the method position are also lost.
5.After a password is successfully entered (or if a password was not specified for the selected protocol), the display will read:
Edit name
4: NAME_04 | COPY |
56 | Opsys MW™ User’s Guide |
