Dynex 91000051 manual To modify a wash operation, Modifying a Wash Protocol

Modifying a Wash Protocol

To modify a wash operation:

1.Select EDIT while the operation is displayed. The first step in the operation is displayed:

Start strip? 1 Cycles

Note: The actual step that is displayed depends upon the operation being modified.

2.Modify the operation, using the same procedures as when creating a new wash protocol.

MOVE 1-10	1 Cycles
DELETE	EDIT

Note: In the example above, the End Strip was changed from 12 to 10. The actual values that are displayed will depend upon the operation being modified and the new value(s) entered.

Note: Once the move loop is modified, the display will no longer read as shown above. Instead, it will display the first command in the move loop or End of Move.

3. Press ENTER to display the next step on the wash protocol.

58 Opsys MW™ User’s Guide