Dynex 91000051 High Waste Level, X Motor Home, Z Motor Home, Test Too Large is, Replace filter

Operational Problems

Symptom	Probable Cause	Resolution
Aspiration is not	Hydrophobic filter	Replace filter.
complete.	may be
(continued)	obstructed.
High Waste Level	The Waste	Empty the Waste
is displayed.	Container is full.	Container (see page 70).
	The waste level	Connect the waste level
	sensor cable is	sensor cable (see
	not plugged in.	page 17).
	The waste level	Service is required.
	sensor connector
	is defective.
	The waste level	Service is required.
	sensor detector is
	reversed.
	The waste tubing	Remove the waste tubing
The waste
container is	is blocked.	from the rear of the
deformed.		instrument (see page 17).
		Check the waste tubing
		(and aspiration tubing)
		and remove any
		blockages or kinks.
	The waste	Replace the waste
	container is	container.
	damaged or
	defective.
	Motion of the	Check the wash head
X Motor Home
Error is displayed.	wash head is	vicinity and remove any
	being blocked.	obstacles.
	The motor is	Service is required.
	defective.
Z Motor Home	Motion of the	Check the wash head
Error is displayed.	wash head is	vicinity and remove any
	being blocked.	obstacles.
	The motor is	Service is required.
	defective.
Test Too Large is	The wash	Reduce the number of
displayed.	protocol exceeds	steps in the wash protocol
	the memory limit.	and try again.

80 Opsys MW™ User’s Guide