Emerson 00809-0100-4102 Rosemount 2051 Wireless Troubleshooting, Symptom Recommended Actions

Reference Manual	Section 5: Troubleshooting
00809-0100-4102, Rev AA	May 2013
Table 6-2. Rosemount 2051 Wireless Troubleshooting
Symptom	Recommended Actions
Transmitter will not respond to changes in	Check test equipment
applied pressure	Check impulse piping or manifold for blockage
	Verify applied pressure is within sensor limits
Digital Pressure Variable reading is low or	Check test equipment (verify accuracy)
high	Check impulse piping for blockage or low fill in wet leg
	Verify transmitter is calibrated properly
	Verify pressure calculations for application
Digital Pressure Variable reading is erratic	Check application for faulty equipment in pressure line
	Verify transmitter is not reacting directly to equipment turning on/off
LCD display is not functioning	Reseat the LCD according to “Installing the LCD display” on page 46
	Verify that the LCD display is a wireless LCD Meter. An LCD from a wired device will
	not function in a wireless device. Rosemount part number: 00753-9004-0002
	Verify that the LCD display mode is not disabled.
Table 6-3. Wireless Network Troubleshooting
Symptom	Recommended Actions
Device not joining the network	Verify network ID and join key
	Wait longer (30 min.)
	Enable High Speed Operation (Active Advertising) on Smart Wireless Gateway
	Check Power Module
	Verify device is within range of at least one other device
	Verify network is in active network advertise
	Power Cycle device to try again
	Verify device is configured to join. Send the “Force Join” command to the device
	See troubleshooting section of Smart Wireless Gateway for more information
Short battery life	Check that “Power Always On” mode is off
	Verify device is not installed in extreme temperatures
	Verify that device is not a network pinch point
	Check for excessive network rejoins due to poor connectivity
Limited Bandwidth Error	Reduce the Update Rate on transmitter
	Increase communication paths by adding more wireless points
	Check that device has been online for at least an hour
	Check that device is not routing through a “limited” routing node
	Create a new network with an additional Smart Wireless Gateway

Troubleshooting 87