Emerson 00809-0100-4102 manual Troubleshooting Reference Manual

Section 6: Troubleshooting	Reference Manual
May 2013	00809-0100-4102, Rev AA

6.2.1Warnings ()

Explosions could result in death or serious injury:

Installation of this transmitter in an explosive environment must be in accordance with the appropriate local, national, and international standards, codes, and practices. Please review the approvals section of the 2051 reference manual for any restrictions associated with a safe installation.

Before connecting a HART-based communicator in an explosive atmosphere, make sure the instruments in the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions.

This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.

This device must be installed to ensure a minimum antenna separation distance of 8 in. (20 cm) from all persons.

Process leaks may cause harm or result in death.

To avoid process leaks, only use the o-ring designed to seal with the corresponding flange adapter.

Electrical shock can result in death or serious injury.

Avoid contact with the leads and the terminals. High voltage that may be present on leads can cause electrical shock.

Table 6-1. Rosemount 2051 Wireless Device Status Information

Device Status	Description	Recommended Action
Electronics Failure	An electronics error that could	1.	Reset the device
	impact the device measurement
	reading has occurred.	2.	Reconfirm all configuration items in the device
		3.	If the condition persists, replace the electronics
Radio Failure	The wireless radio has detected a	1.	Reset the device
	failure or stopped communicating.
		2.	If the condition persists, replace the electronics
Supply Voltage	The supply voltage is too low for	1.	Replace the Power Module
Failure	the device to function properly.
Electronics Warning	The device has detected an	1.	Reset the device
	electronics error that does not
	currently impact the device	2.	Reconfirm all configuration items in the device
	measurement reading.
		3.	If the condition persists, replace the electronics

84 Troubleshooting