Emerson Process Management IB106-340 instruction manual Effective Oct., 1998 Rev

HIGHLIGHTS OF CHANGES (CONTINUED)

	Effective May, 1998 Rev. 2.0 (Continued)
Page	Summary
Page 6-4	Updated Figure 6-3 to include last calibration failed alarm.
Page 6-6	Added fault 14 to Table 6-1.
Page 6-14	Added NOTE to determine when to replace the diffusion element.
Page 7-1	Added general troubleshooting information to paragraph 7-1. Added 4-20
	mA line output information to paragraph 7-3 and Table 7-1. Added fault
	14 to Table 7-1.
Page 7-8	Modified the case temperature in paragraph 7-3.f.1.
Page 7-15	Added new paragraph 7-3.n and Figure 7-14 to explain a last calibration
	failed indication and troubleshooting instructions.
Page 8-1	Updated European address.
Pages 10-1 through	Added Section 10, Optional Accessories.
10-4

	Effective Oct., 1998 Rev. 2.1
Page	Summary
Page P-3 through P-9 Added Material Safety Data Sheets.
Page 1-5	Changed source of instrument air from required to optional.
Page 2-9	Added CAUTION concerning uninsulated stacks and ambient
	temperatures.
Page 2-10	Added paragraph 2-2.c.3 concerning alarm contacts without
	autocalibration.
Page 2-11	Modified paragraph 2.3. Added paragraphs 2-3.a and b concerning
	autocalibration and alarms contacts.
Page 3-5	Added paragraph 3-3 concerning recommended configurations. Subse-
	quent paragraphs renumbered.
Page 6-10 through	Deleted references in paragraphs 6-5.b, c, and d to remove and install
6-11	oxymitter from stack. Procedures 6-5.b, c, and d renumbered.
Page 6-15	Added paragraph 6-9 Ceramic Diffusion Element Replacement. Subse-
	quent paragraphs renumbered.
Page 7-1	Modified paragraph 7-2 to explain alarm indications will be available via
	HART. Added paragraph 7-3 concerning alarm contacts and autocalibra-
	tion. Subsequent paragraphs renumbered.
Page 7-3	Modified Table 7-1 Diagnostic/Unit Alarm Fault Definitions.
Page 9-1	Changed Figure and Index No., Part Numbers, and Descriptions.