Epson LQ-300+ manual Control Panel Buttons and Lights, Tear Off Font lights

Control Panel Buttons and Lights

Tear Off (Font) lights*

Flash when continuous paper is in the tear-off position; otherwise, the lights indicate the selected font.

LF/FF button**

Feeds paper line by line when pressed and released.

Ejects a single sheet or advances continuous paper to the next top-of-form position when held down.

Paper Out light

On when no paper is loaded in the selected paper source or when paper is not loaded correctly.

Flashes when paper has not been fully ejected or a paper jam has occurred.

Tear Off (Font) button*

Advances continuous paper to the tear-off position.

Feeds continuous paper backward from the tear-off position to the top-of-form position.

*Font select

Load/Eject button**

Loads a single sheet of paper.

Ejects a single sheet of paper if a sheet is loaded.

Loads continuous paper from the standby position.

Feeds continuous paper backwards to the standby position.

Pause button

Stops printing temporarily, and resumes printing when pressed again. When pressed for three seconds, turns on the Micro Adjust mode**. To turn off, press again.

Pause light

On when the printer is

In the Micro Adjust mode, you can select the font to use for printing by pressing the Tear Off button. The Tear Off lights turn on, off or flash to indicate the selected font.

**Micro Adjust mode

When you hold down the Pause button for three seconds, the printer enters the micro adjust mode. In this mode, you can press the LF/FFD and Load/EjectU buttons to adjust the top-of-form or tear-off position. See “Using the Printer” on page 13

paused.

Flashes when the printer is in the Micro Adjust mode**.

Flashes when the print head has overheated.

14Using the Printer