0 slash
The zero character has a slash (0) when this feature is turned on. It has no slash (0) when this feature is turned off. The slash allows you to easily distinguish between the uppercase letter O and a zero.
High speed draft
When you choose On, the printer prints up to 413 cps (characters per second) at 10 cpi (characters per inch). When you choose Off, the printer prints up to 310 cps at 10 cpi.
I/F (interface) mode
The printer comes with a
If your printer is connected to only one computer, select Parallel or Serial for the interface mode, depending on the interface you
use. If your printer is connected to two computers, select Auto (automatic) to allow the printer to automatically switch between interfaces depending on which one is receiving data.
Auto I/F (interface) wait time
This setting takes effect only when “I/F (interface) mode” on page 20 is set to Auto. This setting determines how long the printer waits when it no longer receives data from an interface before it
checks whether a print job is being sent through the other interface. You can specify 10 seconds or 30 seconds for the auto
interface wait time.
Baud rate
Use this option to set the data transfer rate (baud) for the serial interface. The baud rate is measured in bits per second (bps). See your computer manual and software documentation for the proper setting.
20Using the Printer
