Epson USN 52L, USN 52R manual Operating the DGS

Storing a new probe Operating the DGS

–Enter a probe name as follows:

–Simultaneously press N and O allocated to the function P-NAME.

You will see the following display:

The cursor flashes at the entry position.

In the two lower lines you will see letters, numbers and characters which you can use for the data set name.

To enter the required text, start by selecting the entry position in each case, and then select the character which should be inserted at this position.

The entry position and character are always marked by a flashing cursor. You can enter all required characters in any chosen order.

–Press the keys T or V in order to change the entry position.

–Press the keys N or O next to the corresponding character string in order to select a character. The flashing cursor changes the string automatically. The highlighted character is immediately inserted at the entry position.

–Finally, press the key X to store the entries.

HNote:

The probe name is stored together with the data set. You can use the same probe name for more than one data set if the probe parameters differ. However, we strongly recommend you to use different probe names for different probes.

Krautkramer USN 52R/USN 52L Option DGS Issue 02, 03/99 DGS-19