Data set names

Operation

 

 

DATA SET NAME Entry of a data set name

This function is used for entering the data set name.

Operation:

Highlight the left function group in the center function table using JC.

Select the required data set number with M.

Simultaneously press N and O allocated to the function DATA SET NAME.

You will see the following display:

The cursor flashes at the entry position of the inverted field of the menu.

In the two lower lines you will see letters, numbers and characters which you can use for the data set name.

To enter the required text, start by selecting the entry position in each case, and then select the character which should be inserted at this position.

The entry position and character are always marked by a flashing cursor. You can enter all required characters in any chosen order.

Press the keys T or V in order to change the entry position.

Press the keys N or O next to the corresponding character string in order to select a character. The flashing cursor changes the string automatically. The highlighted character is immediately inserted at the entry position.

Finally, press the key X to store the entries.

The data set name is now stored together with the data set number and also appears in the function group MEM in the first operating level.

Krautkramer USN 52R/USN 52L

Issue 05, 02/00

5-51

Page 96
Image 96
Epson USN 52L, USN 52R manual Data SET Name Entry of a data set name