Extron electronic IPI 100 Series manual AAP mounting screws These four screws are permanently

<100’ (30.4 m)

R	INTERCOM
	AUDIO OUT

HOST

CONTROL

1=DIGITAL I/O

2=Tx 3=Rx 5=GND

38400, N, 8, 1

LAN	PRESS TAB WITH
	TWEEKER TO REMOVE

IPI 101 AAP or IPI 104 AAP	MLC 226 IP Rear Panel
Rear Panel

ÅLAN port (IPI 201 AAP and 204 AAP only) — Plug an RJ-45 jack into the LAN connector to connect to a network. The blinking yellow LED indicates LAN activity. The green LED lights to indicate a good LAN connection.

Patch (straight-through) cable					Crossover cable			Side	Clip Down
	Side 1		Side 2		Side 1		Side 2		1 2 3 4 5 6 7 8 Pins
Pin	Wire color	Pin	Wire color	Pin	Wire color	Pin	Wire color		RJ-45
1	White-orange	1	White-orange						connector
				1	White-orange	1	White-green
2	Orange	2	Orange	2	Orange	2	Green
3	White-green	3	White-green	3	White-green	3	White-orange
4	Blue	4	Blue	4	Blue	4	Blue
5	White-blue	5	White-blue	5	White-blue	5	White-blue		1 2 3 4 5 6 78
6	Green	6	Green	6	Green	6	Orange
7	White-brown	7	White-brown	7	White-brown	7	White-brown		Twisted
8	Brown	8	Brown	8	Brown	8	Brown
									Pairs
								1&2	7&8
									3&6 4&5
	B	AAP mounting screws — These four screws are permanently
		attached to the IPI’s faceplate. They are used for mounting the

faceplate into another device (such as an MLC 226 IP AAP) or a mounting frame.

	N Steps C to E apply to the IPI 201 and IPI 204 models.
C	Power — Connect a cable between the 2-pole, 3.5,mm captive
	screw connector and a 12 VDC, 2 A power supply (included).
D	Contact Relay — The contact relay connector is used to control
	items such as room lighting, window coverings, and door locks.
	The contact may be used to control any equipment as long as the
	contact specifications of 24 VDC at 1 A are not exceeded.

IPI 100 AAP, IPI 200 AAP Series • Installation 2-7