FOCUS Enhancements FS-2E Connecting the FS-2/2E to a Network, Setup Network Settings Services

Using the FS-2/2E

3.6 Connecting the FS-2/2E to a Network

You can connect the FS-2/2E to a network using the Ethernet 10/100 Base T port on the rear panel. Do the following:

1.Use a standard RJ85 cable to connect between the Ethernet port on the rear panel to a network.

FS-2E Rear Panel

Ethernet 10/100 Base T Connector

2.Power up the FS-2/2E and make sure your network is functioning properly. Contact your system administrator for additional help.

3.Navigate to the FS-2/2E NETWORK menu.

Once in the menu, open the IP SETTINGS sub menu.

4.Select either DHCP (network supplies the IP address) or CUSTOM IP and enter the IP address, Sub Net Mask and Gateway). Exit when done.

5.If your network requires a user name or password, navigate to

USER/PASSWORD and enter both.

6.Exit the NETWORK SETTINGS menu and the FS-2/2E attempts to log onto the network.

Make sure the services you intend to use are enabled. These are enabled using

SETUP > NETWORK SETTINGS > SERVICES.

Use HDD Bypass Mode for Transferring Large Files

The performance of transferring files utilizing the FS-2/FS-2E ftp server is not faster than real time. It is recommended that HDD Bypass mode is used to transfer larger files. The web control interface can be used to remotely place the FS-2E into HDD bypass mode. For more information, see HDD Bypass on page 50 and Web Interface on page 74.

FS-2/2E Studio DTE Disk Recorder User Guide 98