Introduction
To set up the
1.Plug in the power cord.
2.Connect a Video input device.
3.Connect an Audio source (if desired).
4.Connect a Monitor if desired.
5.Connect Speakers or Headset (to monitor the audio) if desired.
6.Connect a Tape Drive if desired.
7.Connect a Time Code Generator if desired.
8.Connect an External Control Device (RS422) if desired.
9.Connect a Reference Video signal if desired.
1.9.1Formatting the Drive
Use this procedure to format the
1.From the Utilities menu, select FORMAT DISK as shown below. When you make this selection, the following screen appears:
FORMAT DISK |
|
|
| |
VOLUME 1? |
|
|
|
|
SIZE | 115 | Gig |
|
|
FREE | 540 | Min |
|
|
EXIT | YES |
| NO |
|
2. Select between volumes by pressing the | and | buttons. | ||
•When you select the volume and press YES, the following screen appears:
FORMAT WILL
ERASE ALL DATA!!
CONTINUE
FORMAT VOL 1?
EXIT | YES | NO |
•When you select YES, a message indicating that the formatting is progressing appears.
WARNING: FORMAT ERASES ALL DATA ON THE DISK
DRIVE!
3.Press EXIT to return to the menu screen.
13
