FOCUS Enhancements FS-2E manual Time Lapse

FS-2/2E Functions

When the disk capacity’s record time is reached, an additional one-minute (or 2GB) segment is created. After this clip is complete, the oldest one-minute clip (or 2GB segment) is recorded over, followed by each sequential oldest clip.

When you press STOP during a record session, recording stops and clips in the current LOOP RECORD session are saved to disk. They are also saved in a single folder.

Loop Record Only Works with One Disk Drive.

2.5.4.5Still

When you select STILL when REC has begun, a single frame is grabbed.

You can grab a still quickly by pressing SHIFT and REC on the front panel when you are in any record mode.

Use STILL with LOCAL and SYNCRO SLAVE record control modes. If STILL is the record mode when power is cut to the unit or it is turned off, and then rebooted, the FS-2/2E goes to NORMAL REC mode.

2.5.4.6Time Lapse

TIME LAPSE 00:00:00:00

&

MOVES CURSOR

EXIT

You can select an interval of up to twenty-four hours. The interval is the period of time between the FS-2/2E capture of a single frame of video (a value of 00:00:00:00 means no frames will be recorded).

1.	Set REC INTERVAL by pressing the TIME and buttons.
	Select the time in frames (up to 30 for NTSC or 25 for PAL),
	then seconds (up to 59), then minutes up to 59, then hours up
	to 23.
2.	Use	and	keys to scroll between values.

3.Press EXIT to return to the menu screen.

FS-2/2E Studio DTE Disk Recorder User Guide

37