FOCUS Enhancements FS-2E manual Genlock

FS-2/2E Functions

2.Connect a host computer to the TO COMPUTER port on the back of the FS-2E next to the EtherNet port.

FS-2E Backpanel

Ethernet

10/100 Base T

To Computer

2.5.12.21GENLOCK

The GENLOCK menu allows you to select and adjust the reference video source and whether the video out will be locked to the reference video input in playback modes.

•SOURCE - Selects the source of the sync pulses used to time the output video during playback. Choices are:

•REF VIDEO - the reference video port on FS-2/2E's rear panel,

•FREE RUN - reference video is generated internally on the FS-2/2E. When this option is selected the menu is simplified and only the above selections are in the GENLOCK menu.

•SC PHASE - Allows the subcarrier phase to be adjusted between +127 and -128. The default value is set at 0.

Press and hold either or for more than 3 seconds to change the value by increments of ten.

•H PHASE - Allows the horizontal phase to be adjusted between +127 and -128. The default value is set at 0.

Press and hold either or for more than 3 seconds to change the value by increments of ten.

Loop-Through or Terminated Output

If the loop-through jack is not connected, make sure the output is terminated using an external 75 ohm terminator.

FS-2/2E Studio DTE Disk Recorder User Guide

75