Select the [Job/Cache] tab, and select [Check Overlapping (Ultrasonic)] or [Check Overlapping and length] for [Multifeed Detection] under [ADF Option].
Click the [OK] button.

Chapter 5 Various Ways to Scan

Preparation before using this function

1 Start up ScandAll PRO, and select the [Scan] menu J [Scanner Setting].

DThe [TWAIN Driver (32)] dialog box appears.

If the [TWAIN Driver (32)] dialog box does not appear, check the setting in ScandAll PRO by selecting the [Tool] menu J [Preferences] to open the [Setup] dialog box, then confirm that [TWAIN] is selected for [Device Driver] in the [Scan] tab.

2 Click the [Option] button.

DThe [Option] dialog box appears.

3

Operational procedure

1 After a multifeed error occurs, either press the [Send to] button to eject the document from the paper path or open the ADF to remove the document.

2 Close the ADF.

For details, refer to "1.4 Opening/Closing the ADF" (page 24).

When you close the ADF, indication on the Function Number Display changes as follows.

zAlternates between "J" and "2" when a multifeed is detected.

zThe function number flashes when ejecting the documents.

Confirm that the ADF is closed properly. Otherwise, the

！document may not be fed into the ADF.

3 Load the documents back in the ADF paper chute.

If a multifeed by difference in length is detected, either press the [Scan/Stop] button or perform a scan from the computer (do not press the [Function] button). If there is an attachment which is likely to be the cause of the multifeed error, then proceed to the next step.

Check

Function Number Display

Function

[Function] button

Send to

Scan /Stop

[Send to] button

4

DIt returns to the [TWAIN Driver (32)] dialog box.

5 Click the [OK] button in the [TWAIN Driver (32)] dialog box.

DThe settings are saved.

[Scan/Stop] button

Power

106