Chapter 4 How to Use the Operator Panel
Indications on Function Number Display |
|
|
| ||
| Display | Description | |||
|
|
|
|
| |
|
|
| E | Indicates that a device error (alarm) occurred during | |
Display | Description | ||||
| F | initialization or scanning. | |||
|
|
| C | The display will switch between either "E'", "F", "C", "H", "A" | |
8 | Displayed when the scanner has just been powered on. | ||||
| H | or "L", and an "alarm number". | |||
|
|
| |||
|
|
| A | For information about the error details, refer to "Device | |
P | Processing initialization. | ||||
| L | ||||
|
|
| |||
0 | Initialization is almost complete. |
|
| The display will return to ready ("1") if the [Scan/Stop] or | |
|
| [Send to] button is pressed. | |||
|
|
|
| ||
1 | Ready to start scanning. |
|
| When this alarm occurs, turn the power off then back on.If | |
| Indicates that the initialization was successfully completed. |
|
| the problem persists after turning the power back on, | |
| This is referred to as "ready" status. |
|
| contact your FUJITSU scanner dealer or an authorized | |
|
|
|
| FUJITSU scanner service provider. | |
Function | A function number will flash after detecting a multifeed. |
|
| ||
|
|
| |||
| None | The display switches off when the scanner enters power | |||
number | This indication prompts whether or not to memorize the |
| |||
(flash) | overlap pattern. |
|
| saving mode. | |
| For details, refer to "Ignoring Multifeed for a Set Pattern" |
|
|
| |
|
|
|
| ||
|
|
|
| ||
|
|
|
|
| |
c | Indicates that the ADF was opened when the status was |
|
|
| |
(flash) | ready ("1"). |
|
|
| |
| Note that the LED indicator will also flash. |
|
|
| |
| To return to ready ("1") status, close the ADF by |
|
|
| |
| For details, refer to "1.4 Opening/Closing the ADF" (page |
|
|
| |
| 24). |
|
|
| |
| If the display does not return to ready ("1") after closing the |
|
|
| |
| ADF, turn the power off then back on.If the problem still |
|
|
| |
| persists, contact your FUJITSU scanner dealer or an |
|
|
| |
| authorized FUJITSU scanner service provider. |
|
|
| |
|
|
|
|
| |
P | Indicates that the scan was paused by pressing the [Send |
|
|
| |
(flash) | to] button. |
|
|
| |
| Press the [Scan/Stop] button to resume the scan. |
|
|
| |
|
|
|
|
| |
J | Indicates that a temporary error occurred during scanning. |
|
|
| |
U | The display will switch between either "J" or "U", and an |
|
|
| |
| "error number". |
|
|
| |
| For information about the error details, refer to "Temporary |
|
|
| |
|
|
|
| ||
| The display will return to ready ("1") if the [Scan/Stop] or |
|
|
| |
| [Send to] button is pressed. |
|
|
| |
|
|
|
|
| |
65