Chapter 9 Operational Settings
Specifying an Area Not to Detect Multifeed | 3 Select an operation mode and click the [OK] button. | ||||
[Intelligent Multifeed Function] |
|
|
|
|
|
|
| Mode | Description | ||
|
|
|
|
|
|
When there is paper of the same size attached to a |
| Manual mode | Does not memorize the size or location of the | ||
designated location on the page, the scanner memorizes the |
|
|
|
| paper attachment when a multifeed is detected. |
|
|
|
| Ignores the multifeed when you load the | |
location of the attachment and can be configured not to detect |
|
|
|
| documents back in the ADF paper chute and |
multifeeds for that location. Note that you first need to select |
|
|
|
| scan them again. |
[Check Overlapping (Ultrasonic)] or [Check Overlapping and |
| Auto mode 1 | Memorizes the size and location of the paper | ||
length] in either the scanner driver’s setup dialog box or the |
|
|
|
| attachment when a multifeed is detected. The |
multifeed detection setting in "Specifying a Multifeed Detection |
|
|
|
| memorized pattern is ignored from the next |
|
|
|
| scan. | |
|
|
|
| ||
|
|
|
|
| |
| Auto mode 2 | Memorizes the size of the paper attachment | |||
1 Start up the Software Operation Panel. |
| ||||
|
|
|
| when a multifeed is detected. The memorized | |
|
|
|
| pattern (including any length less than the | |
Refer to "9.1 Starting Up the Software Operation Panel" (page 153). |
|
|
|
| |
|
|
|
| attachment) is ignored from the next scan. | |
|
|
|
|
| |
2 From the listing on the left, select [Device Setting 2] J |
|
|
|
|
|
|
|
|
|
| |
[Intelligent Multifeed Function]. |
|
|
| z By selecting the [Clear overlap pattern] check box, you | |
|
|
|
| can erase the overlapping patterns (length, position) | |
|
|
|
| that were memorized in Auto mode. | |
|
|
|
| ||
|
|
|
| z In [Remember multifeed pattern at | |
|
|
|
| select whether or not to keep the multifeed pattern | |
|
|
|
| upon turning the power off. When [Remember] is | |
|
|
|
| selected, you can use eight (pages worth) of the most | |
|
|
|
| recent patterns the next time the scanner is powered | |
|
|
|
| on. |
|
|
|
| |||
|
| For details about the procedure after this step, refer to "Ignoring | |||
|
| ||||
185