Chapter 5 Various Ways to Scan
4 Press the [Function] button and confirm that the function
number is flashing faster, and then either press the [Scan/ Stop] button or perform a scan from the computer.
From this point, note that the flashing speed of the Function Number Display switches between "slow" Q "fast" every time you press the [Function] button. When the flashing speed is fast, the scanner operates in each mode as follows:
Do not hold down the [Function] button for more than 5 ！ seconds when switching the flashing speed, because it
may erase the memorized multifeed patterns.
zManual mode (Bypass by front panel button)
Scans the next sheet without multifeed detection, and from the second sheet, multifeeds are detected based on the setting configured in the scanner driver or the Software Operation Panel.
zAuto mode 1 (Bypass by combination of length and position) Memorizes the length and location of the paper attachment that was detected as multifeed, and continues scanning. When a paper attachment of a similar pattern is detected, multifeed detection is automatically suppressed. (*1)(*2)
zAuto mode 2 (Bypass by length)
Memorizes the length of the longest paper attachment that was detected as multifeed, and continues scanning. When a paper attachment of the same length or shorter is detected, multifeed detection is automatically suppressed. (*1)(*2)
*1: 32 pages (up to 4 attachments per page) worth of overlap patterns can be memorized in this mode. When it exceeds this limit, the first pattern that was memorized is erased from the memory.
*2: To erase the memorized overlap patterns and the longest overlap length, hold down the [Function] button for more than 5 seconds while the function number is flashing. The Function Number Display will then display "□". This allows you to erase multifeed patterns and the longest overlap length that were not supposed to be memorized. Be careful with this operation because all memorized patterns will be erased.
107